Important: Do not install
the actual HOUSESAFE unit itself in new or renovated
buildings until all work including floor coverings is completed
and the building has been fully cleaned. The baseplate and wiring
can be installed at any appropriate time during the building
progress.
Excessive dust and debris from the actual building work can
contaminate the sensing chamber, causing problems. This will
also invalidate the guarantee.
Installation of the alarm unit should be left to the end, simply
click fixing into place and commissioning at same time. |
Do not insulate test
this alarm
(i.e. when testing house
wiring with megger, ensure alarm is disconnected).
|
1. Select a suitable location, complying
with advice given, which is wired in the conventional loop
in/out manner as shown below. Ensure mains supply is disconnected
at all times
|
|
Previous - Return
to product - Next
|